The assembly of the acrylic glass display holder with black screen …

First of all remove the inner protective plastic film from the acrylic glass holder, because you cannot take her easy off after the assembly.The outside protective plastic film can remain up to the end of the assembly on the acrylic glass holder, but if you work carefully you can directly take it off.

Here you see a picture from the acrylic glass holder without plastic film …

Then take carefully the protective plastic film off from the black acrylic glass screen and try to touch only one side of the screen and look that this side is lints free as possible.

Here’s a picture of the black screen …

Here’s a picture of the wedges contained in the set
(2x wood and 1x plastic) …

Here a picture from the top of the acrylic glass holder …

Now you put the black acrylic glass plate behind the front screen of the holder, the most beautiful side should come forward: -)) After this look that there’re no lints or finger marks are between the acrylic parts, because after assemblying you can’t clean anylonger between these parts. For cleaning use little detergent or antistatic plastic cleaner on a lint free cloth and everything is clean – please don’t use other cleaning stuff to the acryl parts because they could get scratches on the surface !

Then simply put the two wood wedges at both sides between the frontscreen and the rear mounting plate. The wood wedges may not rise up into the recess of the display, if you cannot put the display in the acrylic holder. Also the recess of the holder front and the recess of the black front screen must fit exactly when assembling.

Now you can insert the display carefully from the rear into the recess, have a look that you don’t scratch with the display. If the distance of the rear mounting plate is not far enough away from the front, push the wood wedges simply again a little bit.

If everything is done, it should look like this ..

You don’t need the black plastic wedge, the pressure between the rear mounting plate for the adjustment of the display is sufficient perfectly.

Here’s a picture from the rear, you see how far the wood wedges have to put in …

Now you pull simply the two wood wedges and the black plastic wedge will be pressed against the display, with which the display is held.

That’s it! Have a look from the rear …

Here’s a pic from the top again …

And a pic from the front – really amazing, it’s a must have on your table … 🙂

For cleaning use little detergent or antistatic plastic cleaner on a lint free cloth and everything is cleaned. Please don’t use other cleaning stuff to the acryl parts because they could get scratches !

Back to the Modding category

And here is the Fanshop where you can buy all explained parts and displays !